NEW AND IMPROVED DESIGN!!!!
These will work with the most popular controllers that use xlights and FPP.
Differential Receiver allows for over 150 feet network RJ45 networking distance from your pixel controller. Adding 4 additional remote ports for delivering more pixels to your show further then tradition 3 wire solutions. With power indicator lights to help show if there is power going to the lights. These boards do not have data lights.
Please ensure you've got the jumper on the correct voltage for your power supply.
5 / 12 volt selection 4 port pixel Differential Receiver allows up to 1600 pixels per port at 20 FPS or 800 pixels per port at 40 FPS for data. Over 40 feet between Differential Receiver to first pixel per port and doubling that distance with a f-amp in between.
Mounting Holes: 50cm spaced
I have not used them yet I only mounted them in a enclosure. I did notice there was not a test button unless I missed it
Works great without issues
I have both the original version and the new version of this board. They work great. I am using the original board for a flood and a pixel to things controller, so they are well under 5 amps total. It has been working without issues. The new version of the board has a different hole pattern than most other receivers, so it will require a different mounting if using it as a replacement. It is also a dumb receiver and cannot be used in smart mode or daisy chained.
4 port diff rec
They work fine but I don't get the data led's to light. May make troubleshooting a little harder in the future.
Not smart but work well
I could not get falcon boards and wanted to run my display on the 4th of July. These boards work like a charm on my Kulp16 AB controller